Now that it is found that your home or business got an exposure of high radon gas level, you want to set up a radon mitigation system in order to reduce the gas level. When it is recommended to work with a radon mitigation contractor to test and perform the mitigation process, you can actually do the work yourself too.

DIY Radon Mitigation
Step-by-Step Guide to Set Up a Radon Mitigation System
A radon mitigation system is performed in order to decrease the amount or level of radon gas in the air. As mentioned above, this job is basically best left to a licensed contractor https://daduonline888.com/ specialized in radon mitigation system. However, in case you are curious how the process is done, the article below will tell you how the installation process is typically finished.
Step 1: Mark the Access of PVC Vent Pipe
For radon mitigation system, a vent pipe is utilized to deliver the gas from where radon source is to the outside of the building or home. Here, a pencil is typically used to mark the zone where the pipe is going to be installed. In most cases, it will be located close to other equipment inside your home such as the system for water heater.
Step 2: Set Up the PVC Vent Pipe
After the area is marked in the previous step, you will need to make some holes based on the marked area. The hole is usually 20-inch in diameter. Then, the PVC vent pipe can be set up while the vent is located in the hole. Here, make sure that the pipe is installed tightly. Next, the pipe is run throughout the walls into the attic.

DIY Radon Mitigation
Step 3: Sealing the Hole
Next, a foam rubber backer rod is going to be situated around the PVC vent pipe base while the area surround it is sealed by using hydraulic cement. Once the hole is sealed, then the PVC pipe will be connected to a venting fan in the attic utilizing metal brackets. The pipe is then carried on from the vent into the roof or roof cap.
Step 4: Finish the Mitigation System Installation
The last, a radon mitigation system is applied in the basement to top the PVC vent. Moreover, a monitor system will be installed too. Once the installation is finished, it is a good idea to carry out a radon test again to make sure that the level of the gas has been diminished after the mitigation system is installed.